Daily Archives: July 17, 2024

Handbrake Installation

Posted on by

We had previously refurbished the handbrake assembly. This was detailed 24:23 minutes into the Bugeye Restoration Video Episode Forty-two. https://vimeo.com/832369002/c87fd61c10?share=copy..  Further handbrake restoration was highlighted at the very beginning of Bugeye Restoration Video Episode Forty-four. https://vimeo.com/842617175/d7a040b143?share=copy

Before we could actually install the handbrake we applied Dynamat Extreme sound insulation to the propshaft tunnel and then glued aluminum duct insulation to the Dynamat Extreme for added heat insulation. We then glued some red vinyl to the area around the handbrake bracket.

Bugeye Restoration Video Episode Forty-eight shows the application of the insulation and the mountng of the handbrake assembly to the tunnel. Once the Rear axle is installed we will connect the handbrake cable to the brake cross rods. https://vimeo.com/986085408/43c579f77a?share=copy

 

Three Point Retractable Harnesses

Posted on by

We had three point harnesses in the Bugeye before restoration; however, the belts were always getting caught in the doors and could cause paint damage. This time around, we decided to install three point retractable belts. We purchased these from Bugeyeguys. https://bugeyeguyparts.com/products/3-point-inertia-seat-belts They are a little on the burgundy side but we think this color will go better with the red in the car than a bright red would.

We fit them before paint because installation required drilling a number of holes in the chassis. The Bugeye Restoration Shoulder Harness Video shows the installation process. https://vimeo.com/985658212/a3227b71de?share=copy