May 26, 2002

Wiring Harness

The wiring harness enters the interior cabin from a large centrally located grommet in the firewall. It splits into three strands.

Strand “A”

Dash panel light switch – 3 wires, 2 red/white stripe to one post. 1 solid red wire to other post.

Heater – 1 solid green wire with bullet connector joint.  1 green/red stripe wire.

Ignition – 2 White wires to left post. 1 Brown wire/blue line to right post.

Strand “B”

Speedometer – 2 black wires soldered to one loop connector to the right post. 

1 Blue/white stripe 

1 Lime green wire 

1 Black wire

Starter Button – 2 solid white wires soldered together to right post on button.

 1 white/red stripe to left post on button.

Dash Light – 1 red/white stripe wire.

Wiper Switch – 1 black wire/green stripe to left post. 1 solid black wire to right post.

Tachometer – 3 solid black wires soldered into one connector, fasten to left post on tachometer. 1 solid white wire – ? 

Lights – 2 red wires soldered together (1)

  2 large brown wires/blue stripe soldered together. (2)

  1 solid large light blue wire. (3)

Fuel Gauge – 2 solid green wires soldered together to left post. 1 green/black stripe to right post.

Overdrive switch – 1 solid white wire to right post. 1 white/purple stripe wire to left post.

Dash Light – 1 red wire/white stripe.